6 replies to this topic

[darway43]

Hi guys,

Just wondering if anyone here has had a roll cage installed by 'Race Fabrications - Simon Built' or 'Alex Bennett' in Adelaide. I have also been told of Walker Chassis but understand he could be very slow, not necessarily a bad thing.
Basically wanting a 6 point cage for my LJ Torana to group n cams specs which they all do. They all seem like great candidates from what I have read but just wanted to hear from anyone else who may have some insight or any other suggestions for builders.


Thanks
Dave

[eyepeeler]

Alex Bennett has done 3 cars for a mate, 2 VC Commodores and 1 Monaro. All cages were constructed very well. The Monaro I have pictured in my IP Torana thread was caged by Alex.

[madtoranajzedded]

Do you know of Frank Zagari in s.a  Dave.his work is the best of seen by miles.an absolute perfectionist

 

im sure he could do it no problems at all

[RallyRed]

,,probably a bit of a haul for you...but I went to Bond Roll Bars in Sydney to get some door bars made to suit my car
( Alloy cage, not Nc approved , but OK for club events , period correct, and all that stuff.).

The guy there , Peter, was super helpful and careful to make sure it was done right.

Regarding steel, CAMS type welded cages there was a RX7 Targa car and an EVO rally car getting done....very tidy work.

Like I said, probably a bit far away, but FYI, and for guys more local.

[darway43]

Alex Bennett has done 3 cars for a mate, 2 VC Commodores and 1 Monaro. All cages were constructed very well. The Monaro I have pictured in my IP Torana thread was caged by Alex.

Thanks for the info that's exactly what I wanted to hear, fills me with a lot more confidence.

Do you know of Frank Zagari in s.a  Dave.his work is the best of seen by miles.an absolute perfectionist
 
im sure he could do it no problems at all

I haven't heard of him but I checked his website out and he also looks like he is more than capable.

,,probably a bit of a haul for you...but I went to Bond Roll Bars in Sydney to get some door bars made to suit my car( Alloy cage, not Nc approved , but OK for club events , period correct, and all that stuff.).The guy there , Peter, was super helpful and careful to make sure it was done right.Regarding steel, CAMS type welded cages there was a RX7 Targa car and an EVO rally car getting done....very tidy work.Like I said, probably a bit far away, but FYI, and for guys more local.

Cheers but probably a bit far. Good info for others in the area as you said.

Thanks guys, next step will head down to their workshops have a chat and see for myself

[darway43]

I can thoroughly recommend Alex Bennet,s work and a nice bloke to go with it

Thanks for the recommendation Wayne. Appreciate it.