Hi I am currently fitting a genuine Holden Lc auto floor shifter. I have the shifter,console and gear indicator panel, but I need to see how the orange needle works and the way the console sits in relation to the shifter I also need to see how the lighting works for e.g where the bulb sits. If anyone can help me it would be much appreciated
1 reply to this topic
#1 _Danny s_
Posted 30 April 2017 - 01:58 PM
#2
Posted 30 April 2017 - 11:34 PM
The orange needle slips over the gear lever
I have a post on here somewhere regarding
the wiring and pics of the needle .i can
only go back a yr on my content.the bulb sits
in the blue holder underneath on the
plastic selection panel.its a very small
Globe holder 7 8mm in size on grey wire
Also affixed to the grey wire is also 3 4?
small bulbs that plug into the back of the
std? dash ilumination panel
I hope thats correct.
Just had a look in general questions and help
Page 7 .i think on page 2.
Once you have a template of the hole theres
Measurements on here from handbrake bolt
hole to where shifter hole should b..once
Shifter is screwed down it should b
relativelyeasy to get the console right with
selector say in park...
Cheers Maz
I have a post on here somewhere regarding
the wiring and pics of the needle .i can
only go back a yr on my content.the bulb sits
in the blue holder underneath on the
plastic selection panel.its a very small
Globe holder 7 8mm in size on grey wire
Also affixed to the grey wire is also 3 4?
small bulbs that plug into the back of the
std? dash ilumination panel
I hope thats correct.
Just had a look in general questions and help
Page 7 .i think on page 2.
Once you have a template of the hole theres
Measurements on here from handbrake bolt
hole to where shifter hole should b..once
Shifter is screwed down it should b
relativelyeasy to get the console right with
selector say in park...
Cheers Maz
Edited by madtoranajzedded, 30 April 2017 - 11:46 PM.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users