18 replies to this topic

[Indy Orange]

Hi , would anyone have one of these standard LJ Torana booster pushrods they would be willing to sell ?Or know who could have one to sell. I need the LJ standard long version to suit my master cylinder.The one pictured borrowed from a mate,Many thanks Paul.

Attached Files

•  07FE5315-7B0C-4F73-AAB6-FB24A3E477B3.jpeg   85.34K   5 downloads

Edited by Indy Orange, 05 September 2021 - 04:19 PM.

[rexy]

Can you get the correct LC depth piston put in your master cylinder or are they NLA?

 

Terry at Hydroboost might have a pushrod to suit.

[Indy Orange]

I'd Say NLA ,Rexy ,the whole kit may be available ,it's just been recoed I wasn't aware it had the deeper LJ primary piston.I think finding a longer pushrod will be easier .

[Indy Orange]

Is this booster pin shared with any other vehicle? Length wise . Thanks Paul.

Attached Files

•  BF534982-7777-4A8B-9706-CA8E2B96F87C.jpeg   85.34K   7 downloads

[73SUNBURSTEXYOUWON]

Who is handy in the fitter n turner walk of life, to machine one up?

[Indy Orange]

Someone's got to have one .But yes Jaso that could be an option.

[S pack]

I kinda remember some time ago a forum member was chasing an issue with a long/low brake pedal and he made up a longer threaded adjustment piece that screws into the end of the pushrod.

[Indy Orange]

Yeah I was thinking the same Dave, whack a bolt in it end and round off the end.But I was advised not to do that by a Brake Shop.

[S pack]

Hey Paul, perhaps give this mob a call, they are a wrecker in WA and have Torana single diaphragm boosters for $50.

https://www.gumtree....lden/1186579961

[Indy Orange]

Thanks mate ,I will ,never saw that.👍

Edited by Indy Orange, 07 September 2021 - 09:38 PM.

[dattoman]

LH fat booster has same rod

[Indy Orange]

Thanks Datto.

[limo]

Dumb question, what is the measurement shown on the picture? My calipers have digital read out.

[claysummers]

I'm reading 69.4mm or 2.73"

early Holden nut

[Indy Orange]

Yes that’s it Clay.

[limo]

I found 3 yesterday that measured a bit over 68mm, roughly with a tape measure. So if I find my calipers they could be right. Found another today that's about 84, don't know what that booster was from.

[Indy Orange]

I reckon that would be it Limo ,give or take a couple of mm with a tape measure.

Edited by Indy Orange, 08 September 2021 - 06:36 PM.

[dattoman]

Sorry... read that wrong

STD skinny booster ... not LH chubby

 

Chubby LH longer

 

 boost rod.jpg   101.46K   4 downloads

 

 boost rod1.jpg   104.63K   4 downloads

 

 boost rod2.jpg   126.76K   2 downloads

 

[Indy Orange]

All good.