Hi,
I am thinking of buying a DIY extractor kit for my LS1 conversion.
It has 2 flange plates and 30 assorted bends to make a set of 4-1 extractors, it comes in 409 stainless and I thought as I only have a simple mig I should do it in mild steel but have been told I can use my mig as I would use it on mild steel to weld the 409 as it will bleed into the wire and be fine.
Any thoughts from you welding guys?
If it works I think it is an achievable task but I am a bit surprised to use a mild steel mig setup
Cheers, Tom