need help on the measurements plz i have found to
measurements in the forums
ones 216 from the door jam qtr edge
the other is hole measurments which puts the badge at 234 from qtr edge
or did they just slap them anywhere ?
Posted 01 March 2017 - 07:53 AM
need help on the measurements plz i have found to
measurements in the forums
ones 216 from the door jam qtr edge
the other is hole measurments which puts the badge at 234 from qtr edge
or did they just slap them anywhere ?
Posted 01 March 2017 - 10:03 AM
Pretty sure you will find the 216mm as in the picture is correct. They certainly didn't just slap them anywhere, though I remember seeing standard LC's that had had the badges attached by owners, and they were slapped any old where. Stick with this, and you can't go wrong IMO. By the way, the holes will be in the same place either side, though the top and bottom of the badge won't necessarily be due to the slope of the badge. I'd use the right side as a template for the badge position. Then measure the hole position once you have the 216mm sorted, and use that hole position as the template on the left side. Hope that makes sense.
Posted 01 March 2017 - 12:55 PM
Wonder if there was a slight difference plant to plant?....assuming they were drilled off a jig, but the jigs were made locally"?
Posted 01 March 2017 - 01:41 PM
Posted 04 March 2017 - 06:44 AM
0 members, 0 guests, 0 anonymous users