Squaring up front of lh lx torana
#1
Posted 13 January 2018 - 07:30 PM
I know the rails have been replaced in my LX hatch at some stage and I want to make sure the front of the car is perfectly aligned.
I have used the corners from the base of the windscreen diagonally across the front of the car and it is Within 1 to 2 mm of measurement to the front nose cone at the same reference points. Also I have measured directly from the corner of the bottom of the front windscreen to the front radiator support panel directly straight in alignment and it also is within 1 or 2 mm.
From that I am guessing that the front of the car is perfectly Square to the firewall rearwards.
Also is there any particular spot on the firewall that is used to measure to the chassis mounting Point holes on the front rails to make sure they are the same from side to side for mounting the front cross member.
#2
Posted 13 January 2018 - 07:46 PM
I have seen a pic on here of chassis measurements, pick up points for suspension ext all measured diagonally. Was sedan and hatch pic.
#3
Posted 13 January 2018 - 08:20 PM
Edited by Shtstr, 13 January 2018 - 08:24 PM.
#4
Posted 13 January 2018 - 09:54 PM
#5
Posted 13 January 2018 - 10:50 PM
Attached Files
#6
Posted 14 January 2018 - 07:59 AM
Thanks Rob that was the one I was thinking of
#7
Posted 14 January 2018 - 11:16 AM
#8 _THE ZODIAC_
Posted 22 July 2018 - 04:49 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users