LX hatch seal channel rust repair
#26
Posted 18 July 2020 - 09:16 PM
#27
Posted 18 July 2020 - 09:24 PM
For my lx, I'm going to keep original and fix the couple of rust bubbles. For my UC, I'll wait or make my own if I get there first.
#28
Posted 18 July 2020 - 09:30 PM
#29
Posted 18 July 2020 - 09:53 PM
108155785_10222991106987663_8605378246591853249_o.jpg 31.97K 1 downloads
107827792_10222991106827659_8532675535594725368_o.jpg 31.77K 1 downloads
#30
Posted 18 July 2020 - 11:02 PM
For my UC, I'll wait or make my own if I get there first.
1/2" square bar is you starting point.
#31
Posted 26 July 2020 - 12:03 PM
How long is that piece and are the correct dimensions available for it? What thickness? Is it just a straight section or is it curved?
Doesn't look that difficult to make up?
#32
Posted 26 July 2020 - 02:32 PM
The rares straight bit I have here is 1128 long.
The rares corners have about 50 to 60mm of straight section on the ends so if you could use these, you would only need about 940 long straight. I guess if it is made 1040 long, some lucky people might get away with keeping their original corners.
Doesn't look hard to make. If I used the rares one above and cut the outside lip, I reckon it would be spot on with another 2.5 to 3mm lip folded over.
M@
#33
Posted 26 July 2020 - 02:42 PM
It may be that it depends which rubber seal you go for would call for a slight different channel.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users