My LH Torana (1975) had some rust taken out of the nosecone a few years back and the guy that did the work filled up the badge letter holes on the nose cone, ground the pins off the letters and glued them back (an inch to high!).
I'm getting a re-spray done at the moment and looking to put the letters back where nature intended and with the pins / holes.
I looked at the Rarespares letters and they were not very good copies in my opinion, so have sourced some original letters and cleaned / repainted them.
All good until I noticed that the "A" comes in two varieties. And with 2 x "A"s in T-O-R-A-N-A I'm trying to find out if the "A"s are different to each other and which one goes where?
One is thicket than the other and has a different casting pattern on the rear profile. The thicker "A" is about 1 mm thicker but and the fixing pins look thicker too. Otherwise they look the same.
Anyone that can help answer this - ie are they different part numbers ? as there seems to be one of each in the sets I have?
Any help appreciated.
LH 1975