Hey Limo
How'd you go with repairing your seats
only the bases needed work, had a spare seat so swapped that base into one and the other has gone to local trimmer to recover.
need to get new backs but haven't decided where to buy yet
Posted 05 March 2019 - 03:45 PM
Hey Limo
How'd you go with repairing your seats
only the bases needed work, had a spare seat so swapped that base into one and the other has gone to local trimmer to recover.
need to get new backs but haven't decided where to buy yet
Posted 06 March 2019 - 06:22 PM
Posted 07 March 2019 - 05:00 PM
no too badly split and nothing to stitch
$300 to have base recovered in matching vinyl
pick up on Monday and see
Posted 01 April 2019 - 04:57 PM
Club cruise yesterday so back together so could drive
stripped all the paint and stuff off of the roof and around screen
IMAG0809.jpg 106.87K 3 downloads
surprised how soft the roof is moving in with pressure
could easily put nasty dents in it
also lots of tiny rust pits so used conditioner
IMAG0814.jpg 78.31K 3 downloads
basically phosphoric acid which reacts with and locks in rust
then etch primer and 2 pak primer filler, will need to be rubbed back and more filler to get
rid of the pock marks from rust pits
IMAG0821.jpg 351.97K 4 downloads
bit of double work as windscreen will come out again to paint but I put it back dry so not much time
won't need to clean off sealer
only a week to next event so might do the hatch and hope not too much rust to fix
have a spare so will pick the best and easiest to fix
Posted 06 May 2019 - 05:45 PM
spare Hatch door better condition only bad section
so will repair that and fit
IMAG0874.jpg 78.68K
2 downloads
didn't feel enthused about doing it now so went to RH guard
IMAG0855.jpg 247.77K 2 downloads
same thing cleaned wire brushed, then etch prime paint and stone guard
IMAG0856.jpg 271.04K 2 downloads
bare metal etch, paint and stone guard inside
" " then 2pac primer
IMAG0873.jpg 285.8K 2 downloads
Back together went to Coffee and Cars yesterday
Posted 06 May 2019 - 05:59 PM
cleaned up driver's floor
IMAG0847.jpg 74.9K 2 downloads
bit of work, hole through both panel sections, inside and out
you can see the ground through floor
IMAG0848.jpg 131.61K 2 downloads
this shows inside repair of hole but floor not finished I have to replace part of floor
on grinding clean lots of pin holes
fortunately have a donor LX
not sure what will be next gear box needs replacement suddenly noisey
also one cross member mounting bolts missing
sheared off in chassis thread so needs to be drilled out and tapped
0 members, 0 guests, 0 anonymous users