can this be done? and if so how. I am using the vr-vs manual ecu. I will be making a custom dash out of auto meter gauges so any info there will be great to !!
bcm bypass
Started by
_shmack_1_
, Apr 18 2007 02:34 PM
2 replies to this topic
#2
REDA9X
-
- Inactive
-
- 0 posts
Removed
- Joined: 08-November 05
Posted 18 April 2007 - 08:13 PM
This one might be better handled through PM's I thnk.
#3
Dr Terry
-
- Moderators
-
- 3,277 posts
Technical + Numbers Guru + Moderator
- Location:Eastwood (Sydney) NSW
- Joined: 13-November 05
Posted 18 April 2007 - 08:55 PM
Hi shmack 1.
I assume you have converted your Torana to 5 litre EFI, using the 082 Delco ECU. If this is the case then, yes, the immobliser system can be by-passed so you don't need a BCM. The mem-cal just has to be re-programmed in the VATS section so it will start without needing the coded signal from the BCM. Most competant chip suppliers/programmers will do this for you.
I don't understand the question about the Autometer gauges, these are not affected by or connected to, the ECU or BCM.
Dr Terry.
I assume you have converted your Torana to 5 litre EFI, using the 082 Delco ECU. If this is the case then, yes, the immobliser system can be by-passed so you don't need a BCM. The mem-cal just has to be re-programmed in the VATS section so it will start without needing the coded signal from the BCM. Most competant chip suppliers/programmers will do this for you.
I don't understand the question about the Autometer gauges, these are not affected by or connected to, the ECU or BCM.
Dr Terry.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
