Does anyone have a picture or diagram of the ignition switch showing which tab the wires go to. The old harness was butchered (and in a bucket) when I bought the car so I got a new American Autowire EZ2wire harness but I don't know which tabs to put the wires on. I tried the trial and error thing and managed to get it to start but had power to the accessories all the time and the fuel pump would only run while cranking the motor. That might be good for economy but it will hard on the battery starting it up every 100 yards. There are numbers on the switch near each tab, similar to a relay, so if anyone knows their code that would do. I'm getting close to having it on the road so am keen to get this sorted ASAP. Thanks in advance.
Ignition switch
Started by
_grounded_
, May 27 2007 02:24 PM
2 replies to this topic
#2
rodomo
-
- Members
-
- 17,999 posts
To advertise here, call 13TORANA
- Name:R - O - B Dammit!
- Location:Way out west of Melbourne Awstraylya
- Joined: 10-December 05
Posted 27 May 2007 - 11:09 PM
What car?
#3
_grounded_
_grounded_
-
- Guests
Posted 28 May 2007 - 10:15 AM
Yes, that is a vital piece of information. It's an LX SLR 5000. It's manual so I don't need the neutral safety switch wires. In the EZ2wire diagram they are wired into the ignition, but that might just be an American thing.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
