What is the easyest way to change bango to a HQ stud pattern? Are HQ axles the same length? or will early commodore axles fit?.
Bango to HQ pattern
Started by
_possessed_
, Jul 04 2006 07:31 PM
7 replies to this topic
#1 _possessed_
Posted 04 July 2006 - 07:31 PM
#2
Posted 04 July 2006 - 07:42 PM
Take your axles and drums to a machine shop and get them to weld up the torana pattern and redrill in HQ pattern. They will also redrill your drums.
#3 _possessed_
Posted 04 July 2006 - 07:56 PM
I have heard that they do not do this anymore because off some legal reason but i will ring and see what they say.
#4 _big chris_
Posted 12 July 2006 - 09:58 PM
Hey possessed,
the easiest way to do it,
buy a set off ebay that are already done.
Will fine spline suit?
TORANA LH-LX-UC FINE SPLINE AXLES (HQ STUD PATTERN)
These are not my auction,
but a very good seller that I have purchased Torana parts from before.
Also a forum memeber I think.
Cheers
Chris.
the easiest way to do it,
buy a set off ebay that are already done.
Will fine spline suit?
TORANA LH-LX-UC FINE SPLINE AXLES (HQ STUD PATTERN)
These are not my auction,
but a very good seller that I have purchased Torana parts from before.
Also a forum memeber I think.
Cheers
Chris.
#5
Posted 12 July 2006 - 10:31 PM
cant you get a set of HQ ones cut and resplined, they run the same bearing eh?
#6 _possessed_
Posted 13 July 2006 - 10:21 PM
Thanks i will keep my eye out for some.
#7 _on the limit_
Posted 13 July 2006 - 11:12 PM
i think you will find that hub or the face of the torana axle is not as wide as the hq hub, there fore hq pattern cannot be drilled onto the torana hub. i could be wrong though! but i tried to change to a commodore pattern & it would'nt fit!
#8
Posted 14 July 2006 - 12:11 AM
possessed: Have you tried Aussie Diffs at Currumbin?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users