5 replies to this topic

[jd lj]

Can someone please post a photo of the correct bolts for the two middle rear bumper brackets?
Are they the same as the 5/16" unc bolts on the bonnet catch and other front end parts?

Thanks

[jd lj]

Also what length are they and do they have both a flat and spring washer?

[grumpy xu1]

Same bolts all through the rear bumper bar brackets all 6 of them. Yes flat & spring washers James, Gary.

[jd lj]

The ones on the two outside brackets have the ends of the thread machined down. Are they the one's that you mean Gary?

[jd lj]

I just looked in the parts catalogue and the 4 outside bracket bolts have a specific part number but the inner ones don't. There appears to be a flat washer on the inside of the boot and a spring washer under the nut on the outside of the bracket.

[S pack]

I just looked in the parts catalogue and the 4 outside bracket bolts have a specific part number but the inner ones don't. There appears to be a flat washer on the inside of the boot and a spring washer under the nut on the outside of the bracket.

James, the bolts are the same for all the brackets. The parts cat drawing only identifies one bolt to one outside bracket. There is no need to identify each individual bracket mtg bolt as they are all the same.

The pic is also a little deceptive as it must be early LC. If you look at your two LJ rear facing brackets you will find the nut is factory electrofusion welded to the bracket. No spring or flat washers can be inserted between the nut and the bracket.
 

Edited by S pack, 08 May 2022 - 10:14 PM.