Can someone please measure an original jack handle. I need the diameter and lengths to fabric a new one thanks
Sent from my iPhone using Tapatalk
Lj jack handle
Started by
[email protected]
, Jun 15 2023 02:01 PM
6 replies to this topic
#1
Posted 15 June 2023 - 02:01 PM
#2
Posted 16 June 2023 - 03:35 PM
Surely someone has one in the shed they could measure to help me out please
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
#3
Posted 16 June 2023 - 06:41 PM
I don't know what car this is out of. May not be a special torana one.....
Pretty much it is2ft exactly from square head to pivot rivet plus 2" for the slip sleeve. 9mm rod. Square drive is 16mm.
See photos for crank. Loos like 15 degree off square.
Sent from my SM-G781B using Tapatalk
Pretty much it is2ft exactly from square head to pivot rivet plus 2" for the slip sleeve. 9mm rod. Square drive is 16mm.
See photos for crank. Loos like 15 degree off square.
Sent from my SM-G781B using Tapatalk
#4
Posted 16 June 2023 - 06:44 PM
This bit wouldn't be hard to do...18# 1" strap.
Seriously just go to a few swapmeets, be a lot easier and about the same amount of fun.
Sent from my SM-G781B using Tapatalk
Seriously just go to a few swapmeets, be a lot easier and about the same amount of fun.
Sent from my SM-G781B using Tapatalk
#5
Posted 16 June 2023 - 06:55 PM
Thanks It is similar to that handle but the Lj torana handle is one piece
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
#6
Posted 16 June 2023 - 07:40 PM
Of course it is, duh.......
Sent from my SM-G781B using Tapatalk
Sent from my SM-G781B using Tapatalk
#7
Posted 02 July 2023 - 12:11 AM
PM me an address and I'll post you an accurate tracing with the diameter etc.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users