6 replies to this topic

[[email protected]]

Can someone please measure an original jack handle. I need the diameter and lengths to fabric a new one thanks


Sent from my iPhone using Tapatalk

[[email protected]]

Surely someone has one in the shed they could measure to help me out please


Sent from my iPhone using Tapatalk

[claysummers]

I don't know what car this is out of. May not be a special torana one.....
Pretty much it is2ft exactly from square head to pivot rivet plus 2" for the slip sleeve. 9mm rod. Square drive is 16mm.

See photos for crank. Loos like 15 degree off square.

Sent from my SM-G781B using Tapatalk

[claysummers]

This bit wouldn't be hard to do...18# 1" strap.

Seriously just go to a few swapmeets, be a lot easier and about the same amount of fun.

Sent from my SM-G781B using Tapatalk

[[email protected]]

Thanks It is similar to that handle but the Lj torana handle is one piece


Sent from my iPhone using Tapatalk

[claysummers]

Of course it is, duh.......

Sent from my SM-G781B using Tapatalk

[jpxu1]

PM me an address and I'll post you an accurate tracing with the diameter etc.