12 replies to this topic

[Shiney005]

I am looking for the one in the picture below that has the purple arrow.  I think this tab is the same as the one attached to the thermostat housing, which is the middle one in the bottom photo. Do the 6 cylinders have them as well?

 Screenshot 2024-01-10 093106.png   1.03MB   8 downloads

 

 L34 wiring tabs small.jpg   156.3K   5 downloads

[yel327]

That's a HX 4.2 Laurie. I can check the part numbers of them if you want.

[hanra]

Mick sold them as a kit. 

[hanra]

Bit different to your pics however? 

 

http://www.toranarpa...-x-lge-1-x-sml/

[Shiney005]

Those ones from RPA will do. I will get a set from Mick.

[arrimar]

Bit different to your pics however?

http://www.toranarpa...-x-lge-1-x-sml/

The small one for the alternator wire that goes on the rocker cover is too short. You can't get a socket on the fastener head easily.

[hanra]

Seemed to work for me?

Attached Files

•  C2FD3370-6BEB-4DF9-BA26-2F052B73BDCB.png   68.77K   4 downloads
•  B2239098-37B7-41CA-9925-C3AB785A1F4A.png   40.33K   3 downloads

[arrimar]

It works Brad, but they're not the same.

Laurie if you want me to send you the big clip shown, text me an address and I'll send it Thursday.

Attached Files

•  Resized_20240110_175958.jpeg   183.47K   3 downloads
•  Resized_20240110_180159.jpeg   267.26K   2 downloads

[Shiney005]

Thanks Howard, but I have already ordered the RPA ones and I think they look like a good replacement for the larger tabs.  I will have a crack at panel beating the smaller one back into shape today.

Got a pic of the two bolts holding the small water inlet housing on the manifold? Mine don't have the AJAX stamped in, although other 1/4 inch bolts on the car don't as well, but they have a small A instead.

[claysummers]

Bit of trivia. I have never seen them on a red six but they look very similar to a tab attached to the lower clutch master to firewall bolt on EK, to retain wiring to dipper switch I think.


Sent from my iPad using Tapatalk

[Shiney005]

My EK is Hydramatic, but I do have a couple of boxes of early bits in the shed so I will have a scrounge in there.

[arrimar]

Thanks Howard, but I have already ordered the RPA ones and I think they look like a good replacement for the larger tabs. I will have a crack at panel beating the smaller one back into shape today.
Got a pic of the two bolts holding the small water inlet housing on the manifold? Mine don't have the AJAX stamped in, although other 1/4 inch bolts on the car don't as well, but they have a small A instead.

That clip in the photo is an RPA one I have left over.

Here's two pics, top pic is my L34 followed by the L31, both have Ajax UNC on one of the bolts per pair.

Attached Files

•  Resized_20240111_191036.jpeg   263.99K   4 downloads
•  Resized_20240111_191216.jpeg   252.59K   4 downloads

[Shiney005]

OK. Perfect. So did mine, but I was assuming one of them was wrong.  The smaller one is a long version of the rocker cover bolts.