Hi I have just replaced my head gasket on my 1974 TA Torana
and i need to know how to ajust the Rocker arms, Tappets?
its a 1300 cc motor.
Any help appreciatded
Bill
tappet ajustment after new head gasket
Started by
_TaTorana_
, Oct 06 2006 03:15 PM
4 replies to this topic
#1 _TaTorana_
Posted 06 October 2006 - 03:15 PM
#2
Posted 06 October 2006 - 09:18 PM
My memory of them says they are wedge adjusters..done with an allen key???
I'll just go on a fact finding tour
I'll just go on a fact finding tour
#3
Posted 06 October 2006 - 09:20 PM
sorry can't help..just crashed the program I was after.
Surely someone has a manual??
Surely someone has a manual??
#4 _TaTorana_
Posted 07 October 2006 - 07:57 AM
Thanks what i need to now is how much to tighten down the valve (pushrod)
covers? Engine is at top dead centre. They are just lock nut holding them in place.
Thanks Bill
covers? Engine is at top dead centre. They are just lock nut holding them in place.
Thanks Bill
#5 _DocDamage_
Posted 07 October 2006 - 09:26 AM
I always did mine on the 1195 LC by ear. I'd tighten to roughly where they were before, start her up and take slack out of any that i could feel movment in, then go through 1 at a time backing off & readjusting by ear, and giving an extra quarter-half turn when you think you have it right, then do the next one. It can be a little messy so put rags down & dont rev it (that gets real messy).
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users